Code: IU.01.09.0007
Version / Revision: 6.001
Page: 75 de 143
Ultrasonic washer
Model: E0201
• The text "Confirm", confirms the action performed and
validates the previous menu;
The "Cancel" button cancels the action performed and returns to the
previous menu.
The E0201 Ultrasonic washers come out of the factory with 7 pre-configured users available for the team to work
properly. For security reasons, it is advisable that these pre-configured users change when they first access the
sterilizer. It is of utmost importance that, when changing users, this information about new users and passwords is
kept safe, to avoid incorrect access, as well as to forget this information. It is possible to return users and the factory
configuration by pressing the "Users default" button on the "MANAGE USERS" screen.
20 users can be edited, including 7 pre-configured at the factory.
After loading the predetermined value of the users, the first 7 registered will be overwritten by standard
users and the rest (from 8 to 20) will be eliminated.
It is recommended to change the password of pre-configured users at the factory before starting the
washing operation.
Without changing pre-configured users' passwords, store the information of these users in a safe
place, since in the absence of this information, it will not be possible to access the user administration
system without assistance from an authorized technician.
There must be less than one user enabled for the "User Configuration" function.
The information and configuration of users pre-configured at the factory is described below:
• User: OP1, OP2 and OP3 (Operator)
• Password: 3785
• Permissions: You have access to the "Start a cycle" menus (even when protected by password).
• User: SUP (Supervisor)
• Password: 1279
• Permissions: You have access to the menus "Start a cycle" (when it is protected by password),
"Program a cycle", "Close and hour", "Cycles completed", "Record of the cycle", "Name of the
institution", "Pre - alarm ", "Pre alarm time", "Start cycle with password" y "Date and time".
• User: CAL (Calibration)
• Password: 6976
• Permissions: It has access to the "Start a cycle" menus (even when protected by password),
"Temperature calibration" and "Pressure calibration".
• User: MAN (Maintenance)
• Password: 2441
• Permissions: They have access to the "Start a cycle" menus (even when protected by password)
and the functions of the "Calibration and maintenance area", with the exception of "Temperature
calibration" and "Pressure calibration".
To Next Page
Loading...