3. Under no circumstances shall Baumer S.A. be liable for any direct, indirect, including loss of profit, special,
incidental or consequential damages, whether based on contract, legal action, damages or other legal theory;
4. In no event shall Baumer S.A.'s liability for material damages exceed the maximum price limit of the Product that
caused such damage.
VII. Additional Warranties
The extended and / or special warranties will be negotiated separately between Baumer S.A. and the Buyer.
After hiring, they will be registered in a specific supply contract for this purpose.
VIII. Others
In accordance with the policy of continuous development, Baumer S.A. reserves the right to make, without prior
notification, changes to the product mentioned in this document.
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any
form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior permission of
Baumer S.A.
5. Installation Requirements
The correct installation of the product, performed by trained and accredited by Baumer technicians, is a necessary
condition for the limited warranty validity of the product to the original purchaser and to guarantee the correct operation
of the equipment.
The Installation Guide is a separate document from this Instruction for Use and it is sent to the purchaser prior to the
arrival of the equipment at the installation site enabling the necessary adjustments for the equipment installation.
The required quality and flow range information for the supplies, the procedures for unloading and removing the
product from package, and information on the required area and conditions for the equipment installation and start-
up are contained in the Installation Guide, which is available to the user by Baumer or its accredited representatives
upon confirmation of the order for delivery.
Please contact MEDIXX, the Baumer group company responsible for the after-sales of our products or our accredited
representatives if this Installation Guide is not available. The contact is on the Medixx Support screen or in the chapter
19.
6. Product specification
The E0201 Ultrasonic washers are built using the best technology available in the areas of mechanics,
thermodynamics, hydraulics, electronics and software, producing robust, safe and high performance equipment.
6.1 Construction
Tank: built in AISI 304 stainless steel, with brushed finish and rounded corners.
Cover: built in stainless steel. The cubicle is sealed by a joint of pure silicone gum and its articulation is restricted by
a piston system. Equipped with a security system that avoids opening, without risk for the operator.
Machine enclosures: built in stainless steel with polished finish.
6.2 Command
Command panel: available in a position that facilitates the operator's visualization and operation.
To Next Page
Loading...