Baumuller b maXX 1000 - Page 103

Parameter
Parameter manual b maXX
®
1000
Document no. 5.07004.03
103
of 208
4
P1154
For further information see ZP1139– or ZP1149– and ZFigure 48– on page 100.
P1155
The parameter are used to set the analog input reference values and is based on percent-
age of ZP0033–).
For further information see ZP1139– or ZP1149– and ZFigure 48– on page 100.
P1156
For further information see ZP1139– or ZP1149– and ZFigure 48– on page 100.
P1157
The parameter are used to set the analog input reference values and is based on percent-
age of ZP0033–).
For further information see ZP1139– or ZP1149– and ZFigure 48– on page 100.
P1158
Example 1: Standard application
P1154
Minimaler ACI3 Strom 0.0 to 20.0 mA
EE Minimum ACI3 current 4.0 mA
STOP BM_u_MinimumACI3Current 10:1
P1155
Minimale ACI3 Frequenz 0.0 to 100.0 %
EE Minimum ACI3 frequency 0.0 %
STOP BM_u_MinimumACI3Frequency 10:1
P1156
Maximaler ACI3 Strom 0.0 to 20.0 mA
EE Maximum ACI3 current 4.0 mA
STOP BM_u_MaximumACI3Current 10:1
P1157
Maximale ACI3 Frequenz 0.0 to 100.0 %
EE Maximum ACI3 frequency 0.0 %
STOP BM_u_MaximumACI3Frequency 10:1
P1158
Bedienfeld Potentiometer Offset 0.0 to 100.0 %
EE Keypad potentiometer bias 0.0 %
ON BM_u_KeypadPotentiometerBias 10:1