Baumuller b maXX 1000 - Page 135

Parameter
Parameter manual b maXX
®
1000
Document no. 5.07004.03
135
of 208
4
P1380
This parameter is used in conjunction with ZP1359– set 4 to input a set point in Hz.
P1381
This parameter is used to set detection of the offset between set point and feedback.
When the offset is higher than the setting of ZP1381– for a time exceeding the setting of
ZP1382–, the b maXX
®
1000 will output a signal when ZP1110– and ZP1117– is set to
16.
P1382
This parameter defines the time during which the PID feedback must be abnormal before
a warning (see ZP1368–) is given. It also can be modified according to the system feed-
back signal time.
P1383
When the actual output frequency ≤ ZP1384– and the time exceeds the setting of
ZP1383–, the b maXX
®
1000 will be in sleep mode.
When the actual frequency command > ZP1385– and the time exceeds the setting of
ZP1383–, the b maXX
®
1000 will restart.
When the b maXX
®
1000 is in sleep mode, frequency command is still calculated by PID.
When frequency reaches wake up frequency, b maXX
®
1000 will accelerate from
ZP0038– minimum frequency following the V/f curve.
P1380
Quelle PID Sollwert 0.00 to 600.00 Hz
EE Source of PID set point 0.00
ON BM_u_SourcePIDSetPoint 100:1 Hz -
P1381
PID Offset 1.0 to 50.0 %
EE PID offset level 10.0 %
STOP BM_u_PIDOffsetLevel 10:1 -
P1382
Ansprechzeit PID Offset 0.1 to 300.0 s
EE Detection time of PID offset level 5.0 s
STOP BM_u_DetectionTimePIDOffsetLevel 10:1 -
P1383
Ansprechzeit Stand-by 0.0 to 6550.0 s
EE Sleep/wake up detection time 0.0 s
STOP BM_u_SleepWakeUpDetectionTime 10:1 -