To Next Page

To Previous Page

156

B-Tronic radio technology

Programming (linking) transmitters

Putting drive into programming

mode

By switching the power on

Switch on the mains voltage at the

B-Tronic radio drive

Via the switch on the drive

Switch the radio switch of the

B-Tronic radio drive to the

posi-

tion.

Via a transmitter that is already

programmed

Press the master button repeatedly

until the drive clicks once . Then

press the programming button

until the drive clicks once .

Programming (linking)

transmitters

Press the programming button on

the new transmitter until the drive

clicks twice .

The status LED lights up green to

confirm that the programming was

successful.

1x click

2x click

Becker M User Manual

Questions and Answers: