Bender NGRM700 User Manual

Menu
52
NGRM7xx_D00292_07_M_XXEN/02.2022
Tab. 7.8: Device settings overview (menu 7)
Explanatory notes Tab. 7.8
1) Summer time (menu 7.2.3)
off No automatic change between summer time and standard time.
DST Daylight Saving Time
Automatic change between summer time and standard time according to North American
regulation. North American summer time begins on each second Sunday in March at 02:00
local time by setting the clock forward by one hour from 02:00 to 03:00 local time. Summer
time always ends the first Sunday in October at 03:00 local time by setting the clock back
one hour from 03:00 to 02:00.
CEST Central European Summer Time
Automatic change between summer time and standard time according to Central European
regulation. Central European summer time begins on each last Sunday in March at 02:00
CEST by setting the clock forward by one hour from 02:00 to 03:00. Central European sum-
mer time always ends on the last Sunday in October at 03:00 CEST by setting the clock back
one hour from 03:00 to 02:00.
7.3
Interface
4)
Modbus TCP (7.3.4) Port 502 (7.3.4.1)
Modbus RTU (7.3.5)
Address (7.3.5.1)
Baud rate (7.3.5.2)
Parity (7.3.5.3)
Stop bits (7.3.5.4)
7.4
Display
5)
Brightness (7.4.1) 0…100 %
Decimal separators (7.4.2) Comma, point
7.5 Password
Password (7.5.1) Factory setting 0000
Status on, off
7.6 Factory settings
Changes are discarded and reset to
factory settings
7.7 Software
Update via interface
6)
UPDATE
7.8 Service For Bender service only
When set to "DST" or "CEST", changing between summer time and normal
time is only done on the date of the official time change.
Menu Parameter Note

Bender NGRM700 Specifications

General

Brand	Bender
Model	NGRM700
Category	Measuring Instruments
Language	English