6 - 11
Periodic maintenance and adjustment
EN
6
To change the engine oil (with or wi-
thout oil lter cartridge replacement)
1. Place the vehicle on a at surface and
keep it upright.
2. Start the engine, warm it up for several
minutes, and then turn it o.
3. Place an oil pan under the engine to col-
lect the used oil.
4. Remove the engine oil ller cap, the en-
gine oil drain bolt and its gasket to drain
the oil from the crankcase.
1. Engine oil drain bolt
TIP
Skip steps 5–7 if the oil lter cartridge is
not being replaced.
5. Remove the cover (1) and replace the
lter element.
1. Oil lter wrench
TIP
Orient the oil lter correctly (like the pre-
vious one), otherwise the motor will be
seriously damaged.
6. Install the engine oil drain bolt and its
new gasket, and then tighten the bolt to
the specied torque.
7. Rell with the specied amount of the
recommended engine oil, and then install
and tighten the oil ller cap.
TIP
Be sure to wipe o spilled oil on any parts
after the engine and exhaust system have
cooled down.
Tightening torque:
Engine oil drain bolt:
22 N·m
1
1
Oil quantity:
Oil change:
2.9 L
With oil lter removal:
3.0 L
To Next Page
Loading...
Need help?
General
