Benelli 502C - Page 147

6 - 12
Periodic maintenance and adjustment
EN
6
NOTICE
• In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not mix
any chemical additives. Do not
use oils with a diesel specication
of “CD” or oils of a higher quality
than specied. In addition, do not
use oils labeled “ENERGY CONSER-
VING II” or higher.
• Make sure that no foreign mate-
rial enters the crankcase.
8. Start the engine, and then let it idle for
several minutes while checking it for oil
leakage. If oil is leaking, immediately turn
the engine o and check for the cause.
TIP
After the engine is started, the engine oil
level warning light should go o if the oil
level is sucient.
NOTICE
• In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not mix
any chemical additives. Do not
use oils with a diesel specication
of “CD” or oils of a higher quality
than specied. In addition, do not
use oils labeled “ENERGY CONSER-
VING II” or higher.
• Make sure that no foreign mate-
rial enters the crankcase.
9. Turn the engine o, wait a few minutes
until the oil settles, and then check the oil
level and correct it if necessary.