Benelli TRK 502 User Manual

Instrument and control functions
3 - 13
EN
3
Catalytic converter
This model is equipped with a catalytic con-
verter in the exhaust system.
WARNING
The exhaust system is hot after operation.
To prevent a re hazard or burns:
• Do not park the vehicle near possible
re hazards such as grass or other ma-
terials that easily burn.
• Park the vehicle in a place where pe-
destrians or children are not likely to
touch the hot exhaust system.
• Make sure that the exhaust system
has cooled down before doing any
maintenance work.
• Do not allow the engine to idle more
than a few minutes. Long idling can
cause a build-up of heat.
NOTICE
Use only unleaded gasoline. The use of le-
aded gasoline will cause unrepairable da-
mage to the catalytic converter.

Benelli TRK 502 Specifications

General

Displacement	500 cc
Transmission	6-speed
Fuel Tank Capacity	20 liters
Seat Height	800 mm
Wet Weight	235 kg
Bore x Stroke	69 mm x 66.8 mm
Compression Ratio	11.5:1
Clutch	Wet multi-plate
Frame	Steel trellis
Wheelbase	1505 mm
Ground Clearance	190 mm
Max Power	47.6 hp (35 kW) @ 8500 rpm
Max Torque	46 Nm @ 6000 rpm
Front Suspension	50 mm upside-down fork
Front Brake	Double floating discs, 320mm, 4-piston calipers
Rear Brake	Single 260 mm disc
Fuel System	Electronic Fuel Injection (EFI)
ABS	Dual-channel ABS
Front Tire	120/70 R17
Rear Tire	160/60 R17
Engine Type	Liquid-cooled, four-stroke, parallel twin cylinder, DOHC, 4 valves per cylinder