Benelli TRK 502 User Manual

EN
6
Periodic maintenance and adjustment
6 - 31
Auxiliary lights
If an auxiliary light does not come on, replace
it as follows.
The following procedure is applied to both
the front lights.
NOTICE
Given that the projector bulb reaches very
high temperatures, we recommend not
touching it with the hands until it has co-
oled down.
1. Remove the right and left inspection lids
2. Disconnect the connectors of the lamp to
be replace
3. Release the xing spring
4. Extract the lamp.
NOTICE
Avoid touching the glass part of the projec-
tor lamp to keep it clean from any oil trace.
On the contrary, the glass transparency,
the duration f the bulb, the luminosity of
the progected light beam maybe aected.
If the bulb becomes dirty, accurately clean
it using a cloth wet with alcohol or thinner
for enamel.
5. Installthe new lamp and x it using the
xing spring.
6. Connect the connectors of the new lamp.
7. Connect the right and left inspection lids.
Auxiliary lights
32

Benelli TRK 502 Specifications

General

Displacement	500 cc
Transmission	6-speed
Fuel Tank Capacity	20 liters
Seat Height	800 mm
Wet Weight	235 kg
Bore x Stroke	69 mm x 66.8 mm
Compression Ratio	11.5:1
Clutch	Wet multi-plate
Frame	Steel trellis
Wheelbase	1505 mm
Ground Clearance	190 mm
Max Power	47.6 hp (35 kW) @ 8500 rpm
Max Torque	46 Nm @ 6000 rpm
Front Suspension	50 mm upside-down fork
Front Brake	Double floating discs, 320mm, 4-piston calipers
Rear Brake	Single 260 mm disc
Fuel System	Electronic Fuel Injection (EFI)
ABS	Dual-channel ABS
Front Tire	120/70 R17
Rear Tire	160/60 R17
Engine Type	Liquid-cooled, four-stroke, parallel twin cylinder, DOHC, 4 valves per cylinder