Benelli TRK 502 User Manual

EN
4
4 - 2
For your safety – pre-operation checks
• Check operation.
• If soft or spongy, have Benelli dealer bleed hydraulic system.
• Check brake pads for wear.
• Replace if necessary.
• Check uid level in reservoir.
• If necessary, add specied brake uid to specied level.
• Check hydraulic system for leakage.
Rear brake
ITEM CHECKS
• Check operation.
• Lubricate cable if necessary.
• Check lever free play.
• Adjust if necessary.
Clutch
• Make sure that operation is smooth.
• Check throttle grip free play.
• If necessary, have Benelli dealer adjust throttle grip free play and lubricate cable and grip housing.
Throttle grip
• Make sure that operation is smooth.
• Lubricate if necessary..
• Make sure that operation is smooth.
• Lubricate pedal pivoting points if necessary.
Control cables
Brake and shift
pedals
• Check chain slack.
• Adjust if necessary.
• Check chain condition.
• Lubricate if necessary.
• Check for damage.
• Check tire condition and tread depth.
• Check air pressure.
• Correct if necessary.
Drive chain
Wheels and tires

Benelli TRK 502 Specifications

General

Displacement	500 cc
Transmission	6-speed
Fuel Tank Capacity	20 liters
Seat Height	800 mm
Wet Weight	235 kg
Bore x Stroke	69 mm x 66.8 mm
Compression Ratio	11.5:1
Clutch	Wet multi-plate
Frame	Steel trellis
Wheelbase	1505 mm
Ground Clearance	190 mm
Max Power	47.6 hp (35 kW) @ 8500 rpm
Max Torque	46 Nm @ 6000 rpm
Front Suspension	50 mm upside-down fork
Front Brake	Double floating discs, 320mm, 4-piston calipers
Rear Brake	Single 260 mm disc
Fuel System	Electronic Fuel Injection (EFI)
ABS	Dual-channel ABS
Front Tire	120/70 R17
Rear Tire	160/60 R17
Engine Type	Liquid-cooled, four-stroke, parallel twin cylinder, DOHC, 4 valves per cylinder