Benelli TRK 502 User Manual

EN
6
6 - 10
Periodic maintenance and adjustment
Canister
This model is equipped with a canister to pre-
vent the discharging of fuel vapor into the
atmosphere. Before operating this vehicle,
make sure to check the following:
• Check each hose connection.
• Check each hose and canister for cracks
or damage. Replace if damaged.
Engine oil and oil lter cartridge
The engine oil level should be checked before
each ride. In addition, the oil must be chan-
ged and the oil lter cartridge replaced at the
intervals specied in the periodic maintenan-
ce and lubrication chart.
To check the engine oil level
1. Place the vehicle on a lat surface and keep
it upright. A slight tilt to the side can result in
a false reading.
2. Start the engine, warm it up for several mi-
nutes, and then turn it o.
3. Wait a few minutes until the oil settles, and
then check the oil level through the engine oil
level check window located at the bottom-ri-
ght side of the crankcase.
TIP
The engine oil should be between the mini-
mum and maximum level marks.
4. If the engine oil is below the minimum level
mark, add sucient oil of the recommended
type to raise it to the correct level.
1. Engine oil level check window
2. Maximum level mark
3. Minimum level mark
2
3
H
L
1
Canister
Engine oil ller cap

Benelli TRK 502 Specifications

General

Displacement	500 cc
Transmission	6-speed
Fuel Tank Capacity	20 liters
Seat Height	800 mm
Wet Weight	235 kg
Bore x Stroke	69 mm x 66.8 mm
Compression Ratio	11.5:1
Clutch	Wet multi-plate
Frame	Steel trellis
Wheelbase	1505 mm
Ground Clearance	190 mm
Max Power	47.6 hp (35 kW) @ 8500 rpm
Max Torque	46 Nm @ 6000 rpm
Front Suspension	50 mm upside-down fork
Front Brake	Double floating discs, 320mm, 4-piston calipers
Rear Brake	Single 260 mm disc
Fuel System	Electronic Fuel Injection (EFI)
ABS	Dual-channel ABS
Front Tire	120/70 R17
Rear Tire	160/60 R17
Engine Type	Liquid-cooled, four-stroke, parallel twin cylinder, DOHC, 4 valves per cylinder