4
113
10Nm
9
10Nm
10Nm
ENGINE REASSEMBLY IN THE VEHICLE
∙ Apply the unit clutch actuator to the two 9 fix-
ing screws. Tighten to 10Nm.
∙ Apply the gearbox lever and fasten the screw at
10Nm by applying a medium strength thread-
locker.
Connect the engine ignition unit to the electrical
system.
The Faston connectors must be connected ac-
cording to the corresponding colours (white cable
with white cable, yellow cable with yellow cable).
∙ Apply the start motor cable and tighten the nut
to the indicated torque. Cover the connection
using the specific protective cap.
Secure the electrical system to the clutch pipe
and frame as shown in the figure using plastic
clamps.
To Next Page
Loading...
