3
86
8
10Nm
9
10
4
6Nm
7
6
5
ENGINE CHECKS AND ASSEMBLY
Grease the O-rings on the water hose and insert
the hose 4 in the right crankcase half.
Apply the gasket between the pump body and
clutch cover. Grease the inner diameter of the oil
seal on the pump body 5 and apply the body to
the clutch cover.
Apply washer 6 and water pump impeller 7.
Apply the screw 8 after applying medium strength
threadlocker and tighten at 6Nm.
Couple the water pump cover to the pump body
by applying the two M6x60 screws 9 and the two
M6x30 screws 10. Tighten all screws at a torque
of 10Nm following a criss-cross pattern.
Apply the oil drain plug and tighten to 15Nm.
Insertion of water hose.
Application of water pump impeller.
Complete water pump.
Pump cover.
To Next Page
Loading...
