Binder KT 53 - Selecting the Parameters

KT (E6.1) 07/2015 Page 101/138
16.3 Selecting the parameters
Here you can select the parameters, which shall be displayed graphically. To select the parameters, go to
Menu > Measurement chart > Settings > Parameters
Fixed value
08.03.2013 05:05:06
Submenu “Parameters”
(The menu items “Object temperature” and “Control
outputs” are visible only with optional unit
equipment)
The current setting for each parameter is displayed.
Select the desired parameter
and press the operating button to change its status
On/Off.
The modified setting is displayed.
Parameters
Temperature On
Object temperature On
Control outputs On
Close Home
Press the button “Close” twice to go back to the graphic display. If any parameter was set to “Off”, it will
not be included in the graphical display.