Binder KT 53 - Confirming a Set Alarm

KT (E6.1) 07/2015 Page 94/138
14.4 Confirming a “set” alarm
Fixed value
08.03.2013 15:05:02
Initial view with overtemperature safety controller
alarm.
The buzzer sounds (if not deactivated previously).
Press the “Info” button.
Setpoint
Actual value
Temperature [°C]
25.0
29.8
Fan [%]
100.0
User
Info
Menu
Alarm acknowledgement
08.03.2013 05:05:06
Submenu “Alarms” for alarm acknowledgement.
..\ Home/Alarms
Safety controller overtemperature
Close Reset Home
The initial view is displayed. The alarm is still active, therefore the alarm icon continues to be shown. The
buzzer is off.
If there is another active alarm, you can press the “Info” button again and also confirm the alarm with the
“Reset” button.
The following alarm messages may appear in the “Alarm list”: