CT-600-2 3
Update Schneider firmware, ACP LINK panel HMI ...................................................................... 25
Update software, ACP LINK panel HMI ....................................................................................... 25
Procedure to change the PLC node name that the HMI looks for ............................................... 26
8.3 Electrical panel IO-module (M172) ................................................................................................... 27
Step 1: update program with default configuration, electrical panel IO-module .......................... 27
Step 2: update configuration and parameters, electrical panel IO-module .................................. 27
8.4 Compressor, oil and economizer system modules, CM-SW-01 & CM-IO ....................................... 27
9 Configuration and setup ........................................................................................................................... 30
9.1 Configuration ACP LINK panel, IP addresses and PLC name ........................................................ 30
9.2 Configuration ACP LINK, basic setup .............................................................................................. 30
9.3 Configuration ACP LINK panel, plant specific parameters............................................................... 31
9.4 Configuration, compressor modules (CM-SW-01) ........................................................................... 32
9.5 Configuration, oil and economizer system modules (CM-IO)........................................................... 33
9.6 Configuration, electrial panel IO-module (M172) ............................................................................. 33
9.7 Configuration, variable speed drives (VSD) ..................................................................................... 34
Check of direction of rotation with VSD ........................................................................................ 34
Variable speed drive configuration WEG CFW11 for operation with ACP LINK .......................... 35
Speed set point settings in ACP LINK .......................................................................................... 36
Current calibration factor in ACP LINK ......................................................................................... 37
9.8 Backup and restore of system configuration and settings................................................................ 37
ACP LINK panel PLC (M251) ....................................................................................................... 37
Compressor, oil and economizer system modules (CM-SW-01 & CM-IO) .................................. 38
Electrical panel IO-module (M172) ............................................................................................... 39
9.9 Recovery of data logs ....................................................................................................................... 40
9.10 Configure communication with SCADA system over Modbus ......................................................... 40
10 ACP LINK, user guide .............................................................................................................................. 41
10.1 Home screen (Home) ....................................................................................................................... 41
10.2 User access (login) to ACP LINK panel HMI .................................................................................... 4 2
10.3 Control screen (CTRL) ..................................................................................................................... 42
Regulation / Select Operation Mode ............................................................................................ 43
State ............................................................................................................................................. 44
PID ................................................................................................................................................ 45
Compressors ................................................................................................................................ 45
10.4 Compressor screen (Compr.) ........................................................................................................... 45
10.5 Oil system screen (OilSys) ............................................................................................................... 46
10.6 Economizer system screen (EcoSys) ............................................................................................... 47
10.7 Alarms and warnings screen (Alarms) ............................................................................................. 47
10.8 Trends screen ................................................................................................................................... 48
To Next Page
Loading...