877-877-2269 | blackbox.com
Page 54
Chapter 5: Configuring the Router
Step 1: On the client device, enter the PIN number listed on the router’s Wi-Fi Protected Setup screen. (It is also labeled on the
bottom of the router.)
Step 2: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected Setup process.
Step 3: When the WPS LED is on, the client device has successfully connected to the router.
NOTES:
1. The WPS LED on the router will light green for five minutes if the device has been successfully added to the network.
2. The WPS function cannot be configured if the Wireless Function of the router is disabled. Make sure the Wireless Function is
enabled before configuring the WPS.
5.7.3 Wireless Security
Choose “Wireless 5GHz —> Wireless Security,” then you can configure the security settings of your wireless network.
There are five wireless security modes supported by the router: WPA-Personal, WPA2-Personal, WPA-Enterprise, WPA2-Enterprise,
and WEP.
Figure 5-38. Wireless Security.
• Disable Security—If you do not want to use wireless security, check this radio button. We strongly recommend that you choose
one of the following modes to enable security.
• WPA/WPA2-Personal—This is the WPA/WPA2 authentication type based on pre-shared passphrase. The router is configured by
this security type by default.
- Authentication Type—You can choose the version of the WPA-PSK security on the drop-down list. The default setting is
Automatic, which will select WPA-PSK (Pre-shared key of WPA) or WPA2-PSK (Pre-shared key of WPA) automatically based on
the wireless station's capability and request.
To Next Page
Loading...
