877-877-2269 | blackbox.com
Page 58
Chapter 5: Configuring the Router
3. Delete all or disable all entries if there are any entries already.
4. Click the Add New button.
5. Enter the MAC address 00:0A:EB:B0:00:0B /00:0A:EB:00:07:5F in the MAC Address field.
6. Enter wireless station A/B in the Description field.
7. Select Enabled in the Status drop-down list.
8. Click the Save button.
9. Click the Back button.
The filtering rules that you configured should be similar to the following:
Figure 5-44. Filtering rules screen.
5.7.5 Wireless Advanced
Choose “Wireless —> Wireless Advanced,” then you can configure the advanced settings of your wireless network.
Figure 5-45. Wireless Advanced.
• Transmit Power—Here you can specify the transmit power of router. You can select High, Middle, or Low. High is the default
setting and is recommended.
• Beacon Interval—Enter a value between 20–1000 milliseconds for Beacon Interval here. The beacons are the packets sent by the
router to synchronize a wireless network. Beacon Interval value determines the time interval of the beacons. The default value is
100.
To Next Page
Loading...
