EasyManua.ls Logo

Black Box WRT750A - Local Management; Remote Management

Black Box WRT750A
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
877-877-2269 | blackbox.com
Page 78
Chapter 5: Configuring the Router
TCP-SYN-FLOOD Packets Threshold (5–3600)—The default value is 50. Enter a value between 5–3600. When the current TCP-
SYN-FLOOD Packets numbers is beyond the set value, the router will start up the blocking function immediately.
Forbid Ping Packet From LAN Port—Enable or Disable Forbid Ping Packet From LAN Port. The default setting is disabled. If
enabled, the ping packet from LAN cannot access the router. This function can be used to defend against some viruses.
Click the Save button to save the settings.
Click the Blocked DoS Host List button to display the DoS host table by blocking.
5.13.3 Local Management
Choose “Security —> Local Management,” then you can configure the management rule in the screen. The management feature
allows you to deny computers in a LAN from accessing the router.
Figure 5-74. Local Management.
By default, the radio button “All the PCs on the LAN are allowed to access the Router's Web-Based Utility” is checked. If you
want to allow PCs with specific MAC Addresses to access the Setup page of the router's Web-Based Utility locally from inside the
network, check the radio button “Only the PCs listed can browse the built-in web pages to perform Administrator tasks,” and
then enter each MAC Address in a separate field. The format for the MAC Address is XX:XX:XX:XX:XX:XX (X is any hexadecimal
digit). Only the PCs with MAC address listed can use the password to browse the built-in web pages to perform Administrator
tasks while all the others will be blocked.
After you click the Add button, your PC‘s MAC Address will be placed in the list above.
Click the Save button to save your settings.
NOTE: If your PC is blocked but you want to access the router again, use a pin to press and hold the WPS/Reset button (hole) on
the back panel for about 5 seconds to reset the router’s factory defaults on the router’s Web-Based Utility.
5.13.4 Remote Management
Choose “Security —> Remote Management,” then you can configure the Remote Management function in the screen. This fea-
ture allows you to manage your router from a remote location via the Internet.

Table of Contents

Other manuals for Black Box WRT750A

Related product manuals