デベロッパーの皆様へ
Blackmagic
SDI
Camera
Control
Protocol
Version 1.1
If you are a software developer you can use the SDI Camera Control Protocol to construct devices
that integrate with our products. Here at Blackmagic Design our approach is to open up our
protocols and we eagerly look forward to seeing what you come up with!
Overview
The Blackmagic SDI Camera Control Protocol is used by ATEM switchers, Blackmagic 3G-SDI
Arduino Shield and Blackmagic Camera Remote to provide Camera Control functionality with
supported Blackmagic Design cameras. Please refer to the ‘Using ATEM Software Control’ section of
this manual, or the ATEM Switchers Manual and SDKmanual for more information. These can be
downloaded at www.blackmagicdesign.com/jp/support.
105
デベロッパーの皆 様へ
To Next Page
Loading...
Need help?
General
