Reference Source
Used to select the genlock source. The Studio Camera can lock to program SDI input or
external genlock source. If using an external genlock source, be aware that changing that
source will most likely cause a glitch as the camera locks to the new source.
On Blackmagic Micro Studio Camera 4K, the HDMI overlays will display ‘REF’ on screen when a
valid reference source is detected and the camera is locked to it.
Reference Timing
Allows you to manually adjust the reference timing on a line or pixel basis.
Headset Level
Move the volume slider left or right to increase or decrease audio monitoring levels.
The default setting is 50%.
Headset Mic Level
Move the volume slider left or right to increase or decrease audio microphone input levels.
Thedefault setting is 50%.
Program Mix
Changes the balance of camera sound to talkback sound. The headphones will output audio
following what is displayed on the LCD. For instance, if you are in camera view, camera audio is
heard. And if you are in program view, program audio is heard. The default setting is 0%.
Remote Settings
Blackmagic Micro Studio Camera 4K features an additional menu for setting remote functions
using the S.Bus protocol. This protocol uses 1 connection to control up to 17 channels, and each
of these channels can be mapped to a specific camera function. S.Bus receivers and decoders
can be found in most major hobby stores online as they are often used for radio remote control
of airplane and helicopter models.
Remote settings – Blackmagic Micro Studio Camera 4K.
TIP You can also connect the program return feed from any SDI switcher to your
camera via a Blackmagic 3G-SDI Arduino Shield and display tally on each camera.
AllSDI switchers that have open collector tally outputs are configurable for tally using
the Blackmagic 3G-SDI Arduino Shield. Refer to the section titled ‘Connecting tally
using the Blackmagic 3G-SDI Arduino Shield’ for more information.
2525Settings
To Next Page
Loading...
Need help?
General
