Cleaning and maintenance
EN
108 bora.com
Fig.7.8
Inserting the activated charcoal filter through
the vent opening
u
Guide the left end of the filter into the opening in the
filter housing.
u
Push the activated charcoal filter into the filter
housing until it will go no further (to do this, you can
place one finger between the slats and gradually
push the filter into the housing).
T
The end position of the activated charcoal filter is
reached when the filter has been fully pushed inside
the filter housing.
Fig.7.9
Placing the activated charcoal filter in the end
position
u
Inside the inlet opening push the filter replacement
cover until it comes to a stop in the filter housing
opening.
u
Check that the filter replacement cover is positioned
correctly.
Fig.7.10
Inserting the filter replacement cover
[1] Filter replacement cover
[2] Inlet opening
u
Insert the stainless steel grease filter and the air inlet
nozzle.
u
Reset the filter service display (see"6.3Menu item 3:
Show filter status and reset filter service display").
To Next Page
Loading...
