2. Click <OK> when ready.
PPPoE
Enable or disable the PPPoE feature.
Enter your PPPoE ‘User name’,‘Password’ and IP address supplied by your internet service
provider, and click <Apply>.
You will need to restart your system to automatically connect to the internet (the IP address
will be automatically assigned).
SNMP
SNMP (Simple Network Management Protocol) provides the basic network management frame
of the network management system, and can be used to retrieve basic system health
information. It can also be used to configure the system to send out traps for events such as
system reboot, video loss, hard disk errors, etc.
The SNMP files can be retrieved/received on devices using common tools such as MG-SOFT
MIB Browser. The Management Information Base (MIB) can be downloaded via the Web.
Use the following steps to configure SNMP:
1. Select the ‘SNMP enable’ box.
2. Use the defaults for ‘SNMP port’, ‘Read community’, ‘Write community’, or assign your
settings if required.
3. To set up traps, press <Add> and enter IP addresses and ports of the devices that should
receive the trap notification. Press <Delete> to delete a device from the list.
4. Use the defaults or assign settings for ‘Video loss’ events sent to the trap:
– Single mode (set a time limit for detecting a single video loss to generate the trap)
– Multi mode (set the number of video losses which should occur within a set time to
generate the trap)
Email
Use this screen for the email settings (address, sender, etc.) if you have enabled the field
‘Send email’ in the menus Alarm, Detect and System events.
See the following descriptions for the field settings in this screen:
SMTP Server
Set to the mail server that processes outgoing e-mail for your network. This can be either an IP
address or a Fully Qualified Domain Name (ex. 10.0.0.1 or smtp.example.com)
SMTP Port Number
This is the port the mail server receives e-mail on. The internet standard for e-mail is port 25,
but some servers use different ports to protect against being used to transmit bulk,
unsolicited e-mail.
Anonymous
Select this option to hide the sender details.
User name and Password
If authentication is required, regardless of encryption, enter the User name and Password
provided by your administrator in each field respectively.
Receiver
Enter up to three e-mail addresses that outgoing e-mail should be sent to.
Sender
This is the e-mail address that will appear as the sender of all e-mail originating from the unit.
8.2.5
8.2.6
8.2.7
40 en | Settings
DIVAR 2000 / DIVAR 3000 / DIVAR
5000
2016.09 | v1.0 | AM18-Q0717 Operation Manual Bosch Security Systems
To Next Page
Loading...
Need help?
General
Weight and Dimensions
