PRAESENSA Configure the system | en 55
Bosch Security Systems B.V. Configuration manual 2020-09 | V1.20 | PRAESENSA 1.20
– The multifunction power supply has eight control inputs which could be individual
configured. To do so:
1. Click the +Control inputs category to configure the functionality of the control inputs of
the selected mps.
2. Select, enable or disable each of the following items:
Item Value Description Added functionality at
selected function
MPSn-[#01]‑[#08] Enable /
Disable
Unique name for the
control input. The control
input must be enabled or
disabled (deactivate).
MPSn is an example. See
Add a device, page 41
for
the naming.
Enable: makes the control
input active within the
system.
N.a.
Function
Sets the function of the control input. See also
Call definitions, page 81
.
Make
announcement
Selection See
Action definitions,
page 84
Actions (1-5): Selects the
number of actions for this
control input if it is a Make
announcement action.
Start phased
announcement
Selection See
Action definitions,
page 84
Actions (1-5): Selects the
number of actions for this
control input if it is a Start
action
Stop phased
announcement
Selection See
Action definitions,
page 84
Actions (1-5): Selects the
number of actions for this
control input if it is a Stop
action.
External fault Selection See
Action definitions,
page 84
N.a.
External zone fault Selection See
Action definitions,
page 84
N.a.
Mains supply fault:
External.
Selection See
Action definitions,
page 84
N.a
Acknowledge and/
or reset
Selection See
Action definitions,
page 84
N.a.
Switch control
output
Selection See
Action definitions,
page 84
N.a.
Local BGM source Selection See
Action definitions,
page 84
N.a.
To Next Page
Loading...
