56 en | Configure the system PRAESENSA
2020-09 | V1.20 | PRAESENSA 1.20 Configuration manual Bosch Security Systems B.V.
Item Value Description Added functionality at
selected function
Local BGM on/off Selection See
Action definitions,
page 84
N.a.
Local BGM volume
control
Selection See
Action definitions,
page 84
N.a.
Activation (Act on contact)
Sets the open or closed contact action of the control input.
Contact make Selection The action will be started
or stopped at contact
close.
N.a.
Contact break Selection The action will be started
or stopped at contact
open.
N.a.
Supervision Enable /
Disable
(by default
enabled)
Switches supervision of the
control input on (Enable)
or off (Disable). See the
PRAESENSA installation
manual for supervision
connection options.
N.a.
Submit Button Click the Submit button to
store the settings. Notice
that you always have to
Save the configuration. See
Save configuration, page
102
N.a.
Control outputs
Control outputs can be used to send signals to third party equipment to trigger actions. Each
control output connection has three pins.
For connection options, see the PRAESENSA installation manual. For a functions overview, see
Action definitions, page 84
.
– The multifunction power supply has eight control outputs which could be individual
configured.
1. Click the + of the Control outputs category to configure each individual control output of
the selected MPS.
2. Select, enable or disable each of the following items:
Item Value Description
MPSn-[#01]-[#08] Enable / Disable Enabled on default. Unique name for the control
output. To deactivate, a control output must be
disabled. See
Add a device, page 41
for the naming of
the MPSn.
Function
Sets the functionality of the control output. See also
Call definitions, page 81
.
To Next Page
Loading...
