Brady BradyPrinter i5100 - Suitable Storage Devices and Installation

54
i5100 Conguration Manual
12.4 Writing
The storage devices can be written to in several ways. The most functionally secure way is writing to the storage device
via a data interface.
!
Attention!
ThedeviceselectedasDefault storageiswrittentobydefault.Towritetoanotherdevicespecifythepathnameof
thedeviceinthelename(ProgrammingManual).
Example:
Withdirectprogramming,thecommandsequenceforsavingalabel(leXYZ)hasthefollowingform:
Ms LBL; XYZ CommandforsavingtheleXYZ
J |
H 100,0,T |
S l1;0,0,68,71,104 |ContentsoftheleXYZ
T 10,10,0,3,pt15;memory card |
A 1[NOPRINT] |
Ms LBL End of save command
• Aftertransferofthecommandsequence,theleXYZissavedwiththecommandsfromJtoA.
• OnlyonelabelisprintedeachtimetheleXYZiscalledup.
• The[NOPRINT]parameterincommandAsuppressestheprintingofalabelwhentheleissaved.
• To print the label a variable number of times, use command A [?].
12.5 Storage Device Functions
12.5.1 Load Label
Labels whose descriptions are saved on the storage device can be printed using the Load label function.
 Start menu.
 Select Storage > Load label.
Thedisplayshowstheselectionofexternalstoragedevicesandthelabellesstoredonthedevices.
 Selectalabelandconrmwith .
Ifalabelisselectedwhichwassavedwithaxedcontentsandxedlabelquantity,theprintjobisstarted
immediately.
If additional input on the label description is required, the display requests to enter the variable data.
For label descriptions with a variable label quantity, a prompt to enter the label quantity is displayed.
 Enter the label quantity/variable data and select to start the print job.
12 Storage Devices