Brady BradyPrinter i5100 - Printer Configuration; Control Panel Configuration; Printing Configuration

17
i5100 Conguration Manual
6 Conguration
6.1 CongurationviaControlPanel
AhostofparametersforconguringtheprinterarefoundintheSetup menu.
 Conguretheprinterviathecontrolpanelduringinitialcommissioningandwhenmakingmajorchangestotheopera-
tional conditions.
 For changes required for processing different print jobs use software settings.
i
Notice!
TheSetupmenucanbeprotectedfromunauthorizedaccessviaacodenumber(PIN).
6.1.1 Printing
 Start menu.
 Select Setup > Printing.
Parameter Meaning Default
Heat level Heating value for compensating for the differing thermal behavior of
printheads. Changing this value is then especially necessary if the
printing intensity has changed after replacing the printhead.
 To adapt the printing intensity when using different media, print
speeds or printing contents, you should change the heat level in the
software.
Thesettingsofconguration and software are added together.
The Heat level setting also affects the test printouts.
0
Print speed Basic print speed setting.
Theprintspeedcanbere-speciedforeachprintjobviasoftware.The
basic setting is not changed by this.
The print speed setting also affects the test printouts.
100 mm/s
Print position X Shifting of the entire print image perpendicular to the direction of paper
ow.
The absolute shifting is limited by the margins of the print zone. Those
are determined by the width of the printing line on the printhead.
The setting can also be adjusted by the software.
Thesettingsofconguration and software are added together.
0.0 mm
Print position Y Shiftingoftheentireprintimageinthedirectionofpaperow.With
positivevalues,printingbeginslaterinthedirectionofpaperow.
Shiftingoftheprintimageinthedirectionofpaperowalsoinuences
the peel and cut positions.
 Correct the Peel position and Cut position parameters by the same value
in the opposite direction.
The setting can also be adjusted by the software.
Thesettingsofconguration and software are added together.
0.0 mm