81
Chapter 10
OPTIONAL SPACE ACCESSORIES
Caution: Do not pull on cord to remove connector.
A maximum of three plugs can be stacked upon each other in P2 socket.
Technical Data: 100 – 240V AC~, 50/60 Hz, 0,4-0,2A
Combi Lead SP 12 V (8713133)
The Combi Lead SP can connect up to three pumps. All pumps can then be
operated by one Power Supply SP.
1.) Connect P2 plug of the Combi Lead SP 12 V with the P2 socket on the
back of the pump.
2.) Conn
ect P
2 plug of Power Supply SP with Combi Lead SP.
3.) Push plug of Power Supply SP into the wall outlet.
Note: A maximum of three plugs can be stacked upon each other in P2 socket.
Connection Lead SP (12 V) (8713231)
Install the Connection Lead SP (12 V) in the following way:
1.) Connect plug to socket P2 on back of pump or F3 on SpaceStation.
2.)Put the connection lead into the car socket.
3.) If nece
ssary, remove red adaptor of motor vehicle connector by slightly
turning and simultanously pulling.
The green LED of the electronic box shows the operating voltage.
Caution: Plug into vehicle charger and connect to pump. Do not
connect pump to patient if vehicle battery/generator is powering on.
Short Stand SP (8713135)
The Short Stand SP may be used to hang an infusion container above the pump
in place of a standing IV pole.
1.)Push the PoleClamp on the pump.
2.)Plug the short stand into the aperture on the PoleClamp; make sure
that it audibly locks in.
3.)To remove the short stand press the button where stand attaches to
pole clamp.
Note: Use only one infusion bag with max. 1000ml on the short stand.
To Next Page
Loading...
