Brocade Communications Systems MLXe Series User Manual

120 Brocade MLXe Series Hardware Installation Guide
53-1003030-01
Installing a Brocade MLXe-32 router
2
FIGURE 88 Installing a power supply in a Brocade MLXe-32 router
CAUTION
Carefully follow the mechanical guides on each side of the power supply slot and make sure the
power supply is properly inserted in the guides. Never insert the power supply upside down.
4. Push the power supply front panel toward the back of the router to engage the backplane
connector.
5. Pull the release latch on the power supply front panel up to lock the power supply in place.
6. Use a #2 Phillips to screw the locking screw into place.
7. Install a blank power supply faceplate into each empty slot.
For information about connecting power to the router, refer to “Connecting AC power” on page 121.
1 Power supply indicators 6 Latch handle locked
2 AC OK 7 Power supply blank cover
3 DC OK 8 Pull down on plunger to remove
4 ALM 9 Power supply
5 Latch handle open
Pwr
Active
Pwr
Active
Pwr
Active
Pwr
Activ e
Pwr
Active
Pwr
Active
Pwr
Active
Pwr
Activ e
AC OK
DC OK
ALM
5
6
7
8
9
1
2
3
4

Brocade Communications Systems MLXe Series Specifications

General

Brand	Brocade Communications Systems
Model	MLXe Series
Category	Control Unit
Language	English