Brocade MLXe Series Hardware Installation Guide 151
53-1003030-01
Testing network connectivity
4
Tracing a route
To determine the path through which the router can reach another network device, enter a
command such as the following at any level of the CLI.
Brocade# traceroute 192.33.4.7
Syntax: traceroute host-ip-addr [maxttl value] [minttl value] [numeric] [timeout value]
[source-ip ip addr]
The CLI displays traceroute information for each hop on the route as soon as the information is
received. Traceroute requests display all responses to a given TTL. If there are multiple equal-cost
routes to the destination, the router displays up to three responses by default.
To Next Page
Loading...
Need help?
General
