Brocade Communications Systems MLXe Series User Manual

Brocade MLXe Series Hardware Installation Guide 197
53-1003030-01
Replacing a power supply
6
NOTE
A threshold value of 0 will not automatically shutdown a power supply due to failures.
For Syslog messages, please refer to Appendix A, Using Syslog in the Brocade MLX Series and
Brocade NetIron Family Configuration Guide.
Clearing power supply failure timestamps
Use the power-supply monitoring clear command to clear all collected failure timestamps for a
given power supply, or for all available power supplies.
To clear all collected failure timestamps for a power supply, enter the following command.
Brocade(config)# power-supply monitoring clear 1
This will clear all collected failure timestamps for the Power Supply # 1
Are you sure? (enter 'y' or 'n'): y
To clear all collected failure timestamps for all available power supplies, enter the following
command.
Brocade(config)# power-supply monitoring clear all
This will clear all collected failure timestamps for all available Power Supplies
Are you sure? (enter 'y' or 'n'): y
You are asked to verify this command by entering “yes” or “no”.
Syntax: power-supply monitoring clear decimal | all]
By default, no power-supply monitoring is configured.
The decimal variable specifies a power supply number, The all keyword clears all available power
supplies.
Displaying power supply monitoring timestamps
To display timestamps for failures on any power supply, enter the following command.
Brocade#show power-supply-monitoring
PS-1 PS-2 PS-3 PS-4
1 ) 0 0 0 0
2 ) 0 0 0 0
3 ) 0 0 0 0
4 ) 0 0 0 0
5 ) 0 0 0 0
6 ) 0 0 0 0
7 ) 0 0 0 0
8 ) 0 0 0 0
9 ) 0 0 0 0
10) 0 0 0 0
11) 0 0 0 0
12) 0 0 0 0
13) 0 0 0 0
14) 0 0 0 0
15) 0 0 0 0
16) 0 0 0 0
17) 0 0 0 0
18) 0 0 0 0
19) 0 0 0 0
20) 0 0 0 0

Brocade Communications Systems MLXe Series Specifications

General

Brand	Brocade Communications Systems
Model	MLXe Series
Category	Control Unit
Language	English