Brookfield DV2T - Page 10

Brookeld Engineering Labs., Inc. Page 10 Manual No. M13-167
Note: TheDV2Tmustbeearthgroundedtoensureagainstelectronicfailure!!
 7) TurnthepowerswitchtotheONpositionandallowtheviscometertowarmupfor10
minutesbeforeperformingautozero.
 8) ForCone/Platemodels,refertoAppendixA.
 9) Ifappropriate,connectUSBcable(DVP-202)toUSBportforconnectionofDV2Tto
PC or printer.
 10)ReviewReadMele.TheReadMelecontainsnotesontheDV2TFirmware.Thisle
canbefoundontheCDthatcontainsthePGFlashSoftware.
Temperature
Probe
USB B
USB A
On/Off
Switch
Power Input
Figure I-2