Brookfield DV2T - IV.4.2 Users And Access

Brookeld Engineering Labs., Inc. Page 50 Manual No. M13-167
UserIDfromthedropdownlistandthenentertheirpassword.TheLogInrequirementisremoved
whenthecheckboxisunchecked.
TheAllow Lock Outcheck boxcontrols theRunningViscosityTestLock Outfunction. This
functionisonlyavailablewhenUserLoginisrequired.WhenAllowLockOutischecked,the
usermaylocktheDV2Tduringatest.TheLockOutissetbypressingtheLockIcon found in
theNavigationBarofRunningViscosityTest.AnytouchofthescreenduringtheLockOutwill
showtheuseraLogInscreen.NoactioncanbetakenontheDV2Tuntiltheproperpasswordis
entered.OnlytheUserIDthatwasineffectwhentheLockOutwasinitiatedcanunlocktheDV2T.
ThetestwillcontinuetocollectdataduringtheLockOut.
TheAllowTimedLockOutcheckboxcontrolstheautomaticfeatureofLockOut.SettheTimed
LockOuttimevaluefrom1–99minutes.TheDV2TwillLockautomatically(withouttouchingthe
LockIcon)afterthetestisinitiated(pressRun)whenthescreenhasnotbeentouchedforthetime
specied.Forexample:TimedLockOutissetto1minute;30secondsafterthetesthasbegun,
theoperatorreviewsthetestparametersbytouchingViewsTest;theDV2Twilllockautomatically
1minuteafterthatkeypress(90secondsafterthetestbeganrunning).
TIP:TheLockOutfeaturecanbeusefuliftheoperatormustleavetheDV2Tunattendedduring
a test.
TheLockOutAfterparameterdeneshowmanyfailedLogInattemptsareallowedbeforetheUser
IDislocked.TherangeforLockOutAfteris1–20.OnceaUserIDislocked,theadministrator
mustresetthepassword.
IV.4.2 Users and Access
TheDV2TcanbesetupwithUseraccountstorestrictaccessandenhancedatatracking.Twouser
levelsareavailablewithintheDV2TandeachcanbecustomizedbytheAdministrator.Alluser
accountsrequireapasswordforaccesstotheDV2T.
The User Settingsare dividedinto threecategories; General Settings, DataAccessFunctions,
andViscosityTestSetup.TableIV-1showsthefactorydefaultusersettingsforPowerUserand
User.TheadministratorcancustomizeboththePowerUserandUserthroughthePowerUser
LevelAccessandUserLevelAccessintheUsersandAccessMenu.Placeacheckmarkbeside
anattributethatisavailabletotheuserandremovethecheckmarkfromanattributethatwillbe
unavailabletotheuser.
TIP: UsersandUserAccesssettingscanbeexportedtoaFlashUSBdrive.Thislecanbe
uploadedtoanotherDV2TorDV3TtoquicklyduplicateUsersettings.
TheUserIDutilizedatLogInwillbereectedinasaveddataset.Thisparameterisviewablein
theResultsscreenbyselectingDeviceInfo.
TIP:TheUserIDinformationisonlyvisibleonceadatasetisloadedfrommemory.Anunsaved
datasetwillnotshowtheUserID.
UseraccountscanbemanagedwithintheUsersandAccessmenuthroughEditUsers,AddUser
and Delete User.