Brookfield DV2T - IV.4.8 Calibration Reminder

Brookeld Engineering Labs., Inc. Page 54 Manual No. M13-167
IV.4.8 Calibration Reminder
TheDV2Tcanbeprogrammedtoprovidetheuserwithareminderthatcalibrationisdue.Two
parametersmustbeset:FrequencyinMonthsandStartDate.Whenbothparametersareentered,
theCalibrationReminderscreen(seeFigureIV-11)willcalculateanddisplaythedaywhenthe
reminder will be presented.
ChecktheCalibrationReminderOncheckboxtoactivatethisfeature.
Figure IV-11
TheCalibrationReminderwillbepresentedduringtherstpoweruponorafterthespeciedday.
Themessagebox(seeFigureIV-12)requiresthattheuserpressOKbeforetheAutoZerowillbe
performed.
Figure IV-12
ThecalibrationreminderwillberesetbyBrookeldoryourauthorizedBrookelddealerwhenthe
unit is returned for calibration.