Brookfield DV2T - Page 26

Brookeld Engineering Labs., Inc. Page 26 Manual No. M13-167
Figure III-3
Figure III-4
Single Point:CollectonlyasingledatapointwhentheEndConditionismet.
Single Point Averaging:Specifyanamountoftimeoverwhichtoaveragemeasureddata.
CollectasingledatapointwhentheEndConditionismet.This
datapointisanaveragedvalue.Ifthetimeforaveragingisshorter
thanthetotaltimeforthestep,thentheaveragewillbeperformed
forthespeciedtimeattheendofthetest.
  Example1:TheEndConditionisTimewithavalueof1minuteand30seconds,theSingle
PointAveragingDurationis30seconds,thesingledatapointcollectedfromthis
stepwillbeanaverageofthedatameasuredfrom1minuteto1minute30seconds.