To Next Page

To Previous Page

Brookeld Engineering Labs., Inc. Page 33 Manual No. M13-167

TemperatureistheinputvaluefromaconnectedBrookeldtemperatureprobe.TheDV2Tis

providedwithaDVP-94Yprobethatcanbeinsertedintothetestsampleorawaterbath.The

Cone/PlateversionoftheDV2Tcanbeutilizedwithasamplecupthatincludesanembedded

temperatureprobe.SomeBrookeldaccessoriesincludetemperatureprobes(Thermosel)or

optionalchamberswithembeddedtemperatureprobes(SmallSampleAdapter).Theunitsof

temperaturearedenedintheGlobalSettingssectionoftheSettingsMenu

Thetemperaturedisplaywillbe----whennotemperatureprobeisconnected.

SpeedistheselectedspeedfromtheCongureViscosityTestscreen.

TIP:SpeedcanbechangedbyswitchingtheRunningViscosityTestscreentotheView

Testscreenusingthecommandkeyatthebottomofthescreen.

TIP:WhenSpeedischangedintheViewTestscreen,theTestNamewillbechangedto

unsaved.

Thestatusofthetestcongurationisindicatedinthegreybarabovethedataelds.Aconguration

thathasbeensavedwillbeindicatedbyadisplayofthetestlename.Acongurationthatisnot

savedwillbeindicatedbyadisplayofUnsavedTest.

TheTrendIndicatorBarisdisplayedatthebottomoftheRunningViscosityTestscreen.TheTrend

IndicatorBarshowsthedirectionandmagnitudeofchangeinthemeasuredparameter.Thisbarcan

representeitherthemeasuredViscosityorthemeasuredTorque.Tochangethedisplayedparameter,

touchthedataeld.InFigureIII-7,TorqueisshownintheTrendIndicatorBar.Thisisrepresented

byabluecirclebesidethetorquevalueinthedataeld.WhenQCLimitsareselectedtobeeither

TorqueorViscosity,thelimitswillbeindicatedontheTrendIndicatorBar(seeSectionIII.7).

TwoCommandKeysareavailableontheRunningViscosityTestscreen:ViewTestandStopTest.

Stop Test:Immediatelystopsthecurrenttest.Theuserwillbepresentedwithaconrmation

box.ThetestwillcontinuetorununtilYesisselectedintheConrmationbox.

Ifanydatahadbeencollectedduringthetest,theuserwillbepresentedwith

theResultsscreen(seeSectionIII.9).Ifdatawasnotcollected,theuserwillbe

returnedtotheCongureViscosityTestscreen.

TIP:  If the operator selects “Do not show this message again” within the

Conrmationbox,thentheConrmationboxwillnolongerbedisplayedwhen

StopTestispressed.ThisconditioncanberesetintheDisplaysectionofUser

Settings

View Test: Changetheviewfrommeasurementtotestparametersincluding:Spindle,Speed,

Temperature,EndCondition,DataCollection,QCLimits,Instructions,andDensity.

TheViewTestscreenincludesalivedisplayofTorqueandaTimeparameterthat

showsthetotalelapsedtimeforthetest(seeFigureIII-10).

Brookfield DV2T User Manual

Questions and Answers: