Brookfield DV2T - PG Flash Interface and Examples

Brookeld Engineering Labs., Inc. Page 57 Manual No. M13-167
Spindle: The spindle to be used with this Viscosity
Test.All calculations will be based on this
spindle number.
ReportScreen: Select the view to be presented upon the
conclusionoftheViscosityTest.
SaveResultsPath: Selectifapathforsavingdataistobedened.
Denethesavepath.
PostTestAveraging: Selectthetypeofaveragingtoperformatthe
endofthetest.
Instructions: Document the instructions to present to the
operatorwhenthetestisrun.
TheTest ParameterssectionincludesallViscosityTestprogramcontrolsthatmayvaryifthere
ismorethanoneteststep.
Speed: Speedofrotationofthespindle.
Data Collection: DataCollectionmethod.
TimeInterval: TimeintervalusedforDataCollectionmethods
thatincludeaveraging.
Density: Density value to be used if kinematic viscosity
unitsareselected(cSt,mm2/s).
End Condition: ConditionwhichsetstheendoftheViscosity
Test.
EndConditionValue: ParameterbasedonchosenEndCondition.
QC Limits: Parameter to be used for QC limit indicators.
QCHigh/QCLowLimit ParameterbasedonthechosenQCLimits.
Collect Single Point at Step End: DuringaMultiPointdatacollection,forcethe
DV2Ttocollectadatapointattheendofthe
step(whentheEndConditionisachieved).
IncludeThisStepintoAverageCalculation: Data from this step will be included in the
averagecalculationindicatedbytheselection
inPostTestAveraging.
Add,Insert,DeleteStepButtons
Save Button
TheProgram GridshowsallTestParametersforeachstepinalineview.
AllmeasurementunitscanbesetthroughtheUnitsSetupbutton,seeFigureV-2.Thismenu
canbepinnedtothescreen.Ifthemenuisnotpinned,thenitwillminimizewhenthemouseis
movedoutsideofthewindow.