Installation and Operation Manual
X-VA-MT3809G-MT3810G-eng
Part Number: 541B182AAG
July, 2018
Models MT3809G & MT3810G
2-1 General
This section contains the procedures for the receipt and installation of
the instrument. Do not attempt to start the system until the instrument
has been permanently installed. It is extremely important that the start-up
procedures be followed in the exact sequence presented.
2-2 Receipt of Equipment
When the equipment is received, the outside packing case should be
checked for damage incurred during shipment. If the packing case is
damaged, the local carrier should be notied at once regarding his
liability. A report should be submitted to the nearest Brooks Instrument
location listed on the Global Service Network page on our website:
BrooksInstrument.com/GlobalSupportCenters
Remove the envelope containing the packing list. Carefully remove
the instrument from the packing case. Make sure spare parts are not
discarded with the packing materials. Inspect for damaged or missing
parts.
2-3 Recommended Storage Practices
If intermediate or long-term storage is required for equipment, as supplied
by Brooks Instrument, it is recommended that the equipment be stored in
accordance with the following:
a. Within the original shipping container.
b. Stored in a sheltered area, preferably a warm, dry, heated warehouse.
c. Ambient temperature of 21°C (70°F) nominal, 43°C (110°F) maximum,
7°C (45°F) minimum.
d. Relative humidity 45% nominal, 60% maximum, 25% minimum.
Upon removal from storage, a visual inspection should be conducted to
verify the condition of equipment is "as received".
2-4 Return Shipment
Prior to returning any instrument to the factory for any reason, visit our
website for instructions on how to obtain a Return Materials Authorization
Number (RMA #) and complete a Decontamination Statement to
accompany it: BrooksInstrument.com/Service. All instruments returned to
Brooks also require a Material Safety Data Sheet (MSDS) for the uid(s)
used in the instrument. Failure to provide this information will delay
processing of the instrument.
Instrument must have been purged in accordance with the following:
To Next Page
Loading...
