7. Sewing
7. Sewing
A CAUTION
Turn off the
power
switch
at
the following times, otherwise the machine
may
oper
ate if the foot switch
is
depressed
by
mistake,
which
cou
ld result in injury.
•
Threading
•
When
replacing the bobbin and needle
•
When
not using the machine and
when
leaving the m
achine
unattended
Do
not touch
any
of
the
moving
parts or
press
any
objects again
st
the
machine
while sewing, as
this
may
result in
persona
l injury or
damage
to
be machine.
7-1. Before starting sewing ....
7-2. Sewing operation
S7Cr!1
R / W
• Check that the needle bar is
at
the highest position.
Turn the machine pulley so that the index mark
0 on
the pu
ll
ey
is
almost aligned with the point where belt
cover U and belt cover D meet.
*
If
the machine
is
started while the index mark 0 is
not correc
tl
y aligned,
er
ror message "E-22" will be
displayed (only when memory switch No.14
is
on).
1. Tu
rn
the power switch 0 on.
(The power indicator on the operation panel will light.)
2.
In
sert the
fl
oppy disk
f).
3.
Press the PRO. No. selection switch 0 to select the
desired program number.
4. Press
RIW
switch
0.
• The
fl
oppy disk drive indicator will light and the pro-
gram no. display 0 will show a P while the data is
being read. When reading
is
completed, an ala
rm
will sound and the indicator will
go
out, then the
program n
o.
display 0 will blink the program num-
b
er.
BAS-3
41
E · 342E
27
To Next Page
Loading...
