Brother BAS-341E - Page 50

1 o. DIP switch
• DIP switch @
SWNo.
When ON
@-5
After sewing is completed, work clamp does not automatically rise (only in split mode)
@-6
Clamping force output is produced (Inner clamping device available as an option)
@-7
Single-pedal operation using the starting switch; when the starting switch is pressed,
the work clamp drops, and when it is released, sewing starts.
@-8
Thread breakage detector device is activated (available as an option)
• DIP switch ®
SWNo.
When ON
®-1
Single split mode activated
®-2
-
®-3
Thread is not trimmed after an emergency stop
®-4
Needle cooler output is produced.
®-5
When a rotating-type thread breakage detector device is used, detection precision is increased from 8 to 14.
When a fiber-type thread breakage detector device is used, detection precision is increased from 5 to 10.
@-6
Fiber-type thread breakage detector device is ON, and DIP switch@- 8 is ON (available as an option).
®-7
When using a 3-stage pedal
®-8
Feeding speed is switched to high speed.
BAS·341 E • 342E
43
From the library of: Superior Sewing Machine & Supply LLC