Brother HL-2560DN Service Manual

5-9
Confidential
<Operating Procedure>
(1) Press the [▲] or [▼] key in the initial state of maintenance mode to display
"MAINTENANCE 10" on the LCD.
(2) Press the [OK] key. "WSW00" is displayed on the LCD, indicating that the machine is
ready for worker switch number entry.
(3) Press the [▲] or [▼] key to display the worker switch number for which you want to
change the setting on the LCD.
(4) Press the [OK] key. The following message is displayed on the LCD, and selector No.1
flashes.
(5) Pressing the [▲] key enters "1", and pressing the [▼] key enters "0". Press either to
enter desired number to Selector No.1. The next digit starts flashing.
(6) Keep entering numbers to Selector No.8 using the [▲] or [▼] key as described in the
procedure (5).
(7) Press the [OK] key. The new selector setting value is stored in the EEPROM, and the
LCD returns to the ready state for worker switch number entry ([WSW00]).
(8) When all switch setting is completed, press and hold the [Go] key to return the machine
to the initial state of maintenance mode.
WSWXX = 0 0 0 0 0 0 0 0
Selector No. 1 Selector No. 8

Brother HL-2560DN Specifications

General

Brand	Brother
Model	HL-2560DN
Category	Printer
Language	English