Brother MFC-665CW - Understanding the Error Messages

PhotoCapture Center @)
@
@
Do one of the following.
m To change the quality, go to step 0.
[] Press Black Start or Color Start to
start scanning without changing
additional settings.
Press • or • to choose
150 dpi Color, 300 dpi Color,
600 dpi Color, 200x100 dpi B/W
or200 dpi B/W.
Press OK.
@
Do one of the following.
[] To change the file type, go to step 0.
[] Press Black Start or Color Start to
start scanning without changing
additional settings.
Press • or • to choose JPEG, PDF or
TIFF.
Press OK.
Note
• If you chose color in the resolution setting,
you cannot choose TIFF.
• If you chose black & white in the resolution
setting, you cannot choose JPSG.
Do one of the following.
[] To change the file name, go to
step @.
[] Press Black Start or Color Start to
start scanning without changing
additional settings.
The file name is set automatically
however, you can set a name of your
choice using the dial pad. You can only
change the first 6 digits.
Press OK.
Note .....................................................................................
Press Clear/Back to delete the current
name.
Press Black Start or Color Start.
Understanding the
Error Messages
Once you are familiar with the types of errors
that can occur while you are using the
PhotoCapture Center ®, you can easily
identify and troubleshoot any problems.
When an error message appears on the LCD,
the machine will beep to get your attention.
[] Hedia Error
This message will appear if you put in a
media card that is either bad or not
formatted, or when there is a problem with
the media drive. To clear this error, take
out the media card.
[] No File
This message will appear if you try to
access a media card in the drive (slot) that
does not contain a .JPG file.
Out of Memory
This message will appear if you are
working with images that are too large for
the machine's memory.