Brother MFC-665CW - Using Your Remote Access Code

Advanced fax operations (Black & White only)
Note .....................................................................................
You can change your code at any time by
entering a new one. If you want to make
your code inactive, press Clear/Back in
step O to restore the inactive setting
(----X-)and press OK.
Using your Remote Access
Code
@
@
@
@
Dial your fax number from a touch tone
telephone or another fax machine.
When your machine answers, enter
your remote access code (3 digits
followed by -X-)at once.
The machine signals if it has received
messages:
m 1 long beep -- Fax messages
2 long beeps -- Voice messages
(MFC-665CW only)
3 long beeps -- Fax & Voice
messages
(MFC-665CW only)
No beeps -- No messages
When the machine gives two short
beeps, enter a command.
The machine will hang up if you wait
longer than 30 seconds to enter a
command.
The machine will beep three times if you
enter an invalid command.
Press 9 0 to reset the machine when you
have finished.
Hang up.
Note ...................................................................................
If your machine is set to Manual mode
and you want to use the remote retrieval
features, wait about 2 minutes after it
starts ringing, and then enter the remote
access code within 30 seconds.
83