Brother MFC-665CW - Setting Volume Amplify (MFC-665 CW Only)

General setup
Note ...................................................................................
When you press <l/4 or I_ _)_ on the
control panel to adjust the volume, the
LCD shows the setting you are choosing.
Each key press changes the volume to the
next setting.
It is important that you do NOT choose
Permanent unless ALL the users are
hearing-impaired. Otherwise, the default
setting of Amplify may damage the
hearing of some users.
Setting Volume Amplify
(MFC-665CW only)
Please carefully read Choosing the Handset
Volume (For Volume Amplify) (MFC-665CW
only) on page 28.
Press Menu.
Press • or • to choose
General Setup.
Press OK.
Press • or • to choose Volume.
Press OK.
O Press • or • to choose
Volume Amplify.
Press OK.
Do one of the following.
m If none of the users are hearing-
impaired, press • or • to choose
off, and then press OK and go to
step 0.
[] If some or all of the users are
hearing-impaired, press • or • to
choose On, and then press OK.
Do one of the following.
[] If all the users are hearing-impaired,
press • or • to choose
Permanent, and then press OK.
[] If only some of the users are hearing-
impaired, choose Temporary, and
then press OK.
Press Stop/Exit.
29