Chapter 7
Using remote codes
Fax receive code
If you answer a fax call on an extension or
external telephone, you can tell your machine
to receive it by dialing the fax receive code
-X-5 1. Wait for the chirping sounds then
replace the handset. See Easy Receive on
page 50. Your caller will have to press Start
to send the fax.
Telephone answer code
If you receive a voice call and the machine is
in FIT mode, it will start to sound the FIT
(double) ring after the initial ring delay. If you
pick up the call on an extension phone you
can turn the FIT ring off by pressing # 5 1
(make sure you press this between the rings).
Changing the remote codes
The preset Fax Receive Code is -X-5 1. The
preset Telephone Answer Code is # 5 1. If
you want to, you can replace them with your
own codes.
Press Menu.
Press • or • to choose Fax.
Press OK.
Press • or • to choose
Setup Receive.
Press OK.
O Press • or • to choose
Remote Codes.
Press OK.
Press • or • to choose On (or off).
Press OK.
Enter the new Fax Receive Code.
Press OK.
Enter the new Telephone Answer Code.
Press OK.
Press Stop/Exit.
Note ...................................................................................
• If you are always disconnected when
accessing your external TAD remotely, try
changing the Fax Receive Code and
Telephone Answer Code to another three-
digit code (such as # # # and 9 9 9).
• Remote Codes might not work with some
telephone systems.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii! !62
To Next Page
Loading...
Need help?
General
