Brother MFC-665CW - Volume Settings; Ring Volume; Beeper Volume; Speaker Volume

General setup
Volume Settings
Ring Volume
You can choose a range of ring volume lev-
els, from High to off.
While in Fax mode , press 4) _1or
I_ 4/)) to adjust the volume level. The LCD
shows the current setting, and each key
press will change the volume to the next level.
The machine will keep the new setting until
you change it.You can also change the
volume through the menu, by following the
instructions below:
Setting the Ring Volume from the
menu
Press Menu.
Press • or • to choose
General Setup,
Press OK.
Press • or • to choose Volume.
Press OK.
Press • or • to choose Ring.
Press OK.
Press • or • to choose Low, Hed,
High or of f.
Press OK.
Press Stop/Exit.
Beeper Volume
When the beeper ison, the machine will beep
when you press a key, make a mistake or
after you send or receive a fax.
You can choose a range of volume levels,
from High to off.
Press Menu.
@
@
@
@
Press • or • to choose
General Setup,
Press OK.
Press • or • to choose Volume.
Press OK.
Press • or • to choose Beeper.
Press OK.
Press • or • to choose Low,Hed,
High or off
Press OK.
Press Stop/Exit.
Speaker Volume
You can choose a range of speaker volume
levels, from High to Off.
@
@
@
@
@
Press Menu,
Press • or • to choose
General Setup,
Press OK.
Press • or • to choose Volume.
Press OK.
Press • or • to choose Speaker.
Press OK.
Press • or • to choose Low, Hed,
High orOff.
Press OK.
Press Stop/Exit.
You can also adjust the speaker volume by
pressing Hook or Speaker Phone.
Press Hook or Speaker Phone.
@ Press 4) _ or I_ _i_).
This setting will stay until you change it
again.
Press Hook or Speaker Phone.
27