Chapter 3
Note ...................................................................................
(MFC-665CW only)
You can adjust the speaker volume while
you are listening to your outgoing
message (OGM) and incoming messages
(ICM's) by pressing 41 < or i_ _).
Handset Volume (MFC-665CW
only)
Press Menu.
Press • or • to choose
General Setup.
Press OK.
Press • or • to choose Volume,
Press OK.
O Press • or • to choose Handset.
Press OK.
Press • or • to choose Low or High,
Press OK.
Press Stop/Exit.
Note .......................................................................................
• You can adjust the handset volume any
time you are talking on the telephone.
There are two handset volume levels, Low
and High. The default setting is Low.
• Press _) <1or I_ _q_!_to adjust the volume
level. The LCD shows the setting you are
choosing. The new setting will remain until
you change it again.
Choosing the Handset
Volume (For Volume Amplify)
(MFC-665CW only)
Before you begin to use the machine, you
must decide if you need to set the handset
volume to Volume Amplify On for a user
who is hearing-impaired. The AMPLIFY
volume level complies with FCC standards.
Volume Amplify Off
This default setting is appropriate if none of
the users are hearing-impaired. During a
conversation, users can press 4) < or I_ _)_
on the control panel to adjust the volume to
sow or High. When the handset is replaced,
the handset volume will remain until you
change it again.
Volume Amplify On - Temporary
This setting is appropriate if some of the
users are hearing-impaired. During a
conversation, users can press ,d)< or I_ _/))
on the control panel to adjust the volume to
Low, High or Ai-_tpli fy. When the handset is
replaced, the handset volume returns to the
default setting of Low.
Volume Amplify:On - Permanent
Choose Volume Amplify On -
Permanent if all of the users are hearing-
impaired. During a conversation, users can
press <l) < or I_ 4))) on the control panel to
adjust the volume to Low, High or Ampl i fy.
When the handset is replaced, the handset
volume returns to the default setting of
Amplify.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii! !28
To Next Page
Loading...
Need help?
General
