If you are not able to find the yellow
protective part, DO NOT remove the ink
cartridges before shipping. It is essential
that the machine be shipped with either the
yellow protective part or the ink cartridges
in position. Shipping without them will
cause damage to your machine and may
void your warranty.
O Unplug the machine from the telephone
wall jack and take the telephone line
cord out of the machine.
Unplug the machine from the AC power
outlet.
@ Using both hands, use the plastic tabs
on both sides of the machine to lift the
scanner cover until it locks securely into
the open position. Then unplug the
interface cable from the machine, if it is
connected.
@ Lift the scanner cover (t) to release the
lock. Gently push the scanner cover
support down (2) and close the scanner
cover (3).
Wrap the machine in the bag and put it
in the original carton with the original
packing material.
®
Pack the printed materials in the original
carton as shown below. Do not pack the
used ink cartridges in the carton.
Note .................................................................................
If you are returning your machine to
Brother as part of the Exchange Service,
pack only the machine. Keep all separate
parts and printed materials to use with
your 'Exchange' machine.
If your machine has a handset, remove
it and the handset curled cord.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii; !152
To Next Page
Loading...
