App. 1-32
Confidential
<WSW29> (Function setting 7)
• Selector 8: Prompt beep for activity report
This selector determines whether or not to beep if the memory area for the activity report
becomes full, for prompting you to print out the report. (Printing it out will clear the memory
area.)
<WSW30> (Function setting 8)
Selector No. Function Setting and Specifications
1
I
3
Compression threshold level for
voice signals inputted via the
telephone line in the built-in TAD
operation (Not used.)
4
I
6
Compression threshold level for
voice signals inputted via the
handset in the built-in TAD
operation (Not used.)
7
Impedance switching control in
pulse dialing
0: OFF 1: ON
8
Prompt beep when the memory
area for the activity report
becomes full
0: No 1: Yes
Note:
• Selectors 7 and 8 are applicable only to the European versions.
Selector No. Function Setting and Specifications
1
I
3
Dial tone/busy tone detection
level during recording of ICM
(Not used.)
4
I
6
Not used.
7
Scanning magnification
adjusting function
0: Enable 1: Disable
8 Not used.